It’s time! IRE – the International Roofing Expo has started in Nashville, TN. It officially runs February 11-13 in Music City Center. The exhibit hall in the Center is located in downtown Nashville – incredible roofing products and within walking distance to restaurants and local music venues. What could be better?
Tags: Solar, Roof Clamps, pv modules, Snow Guards, sliding snow, metal roofs, snow retention, S5 clamps, metal roof clamps, solar mounting, Brackets, metal roofing, standing seam metal roof, snow stopper, snow bar, exposed fastener, roof panels, PV technology, direct mount, PV array, photovoltaic, rail mounted, rail less, solar PV, solar technology, rooftop mounting, rooftop equipment, maintain roof warranty, rooftop utilities, load tested, holding strength, aluminum, stainless steel
Upon reading the Solar Power World article Metal Roofs are No Problem for Solar Installations, my reaction was, "Well, I suppose that is true—if (and only if) it is done 'the right way.'" There are so many materials, profiles, gauges, metallurgies and corrosion behaviors to consider; not to mention effective waterproofing methods, sealant chemistries, thermal cycling characteristics, weathering behaviors, strength of materials, structural engineering principals and relevant test methods. It is anything but a simple science!
Tags: Solar, pv modules, solar mounting, Brackets, solar attachment, exposed fastener, PV technology, PV, direct mount, PV array, photovoltaic, rail less, solar PV, solar technology, rooftop mounting, maintain roof warranty, load tested, holding strength
Best design and installation practices when using seam clamps to structurally attach PV systems to standing seam metal roofs
Standing seam metal roofing (SSMR) is the most convenient of any roof type for mounting PV modules, either crystalline or thin-film. The seams of SSMR are beam-like elements that not only add stiffness and flexural strength to the roof panels, but also provide expedient attachment points for a PV system. Joining PV modules to this roof type can be done with or without continuous mounting rails using aluminum seam clamps.
Seam Clamps and Mechanical Compression
These clamps anchor to the roof seam by pinching it within the clamp body with round point set-screws that are in no way invasive to the roof. The setscrew forces the metal of the standing seam into a recess in the opposing clamp wall, permanently deforming it in order to establish a mechanical interlock. The clamp body is machined with threaded holes to facilitate anchorage of PV modules or racking components to the clamp.